GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 21854-01 Pivot Pin Remover


    Object Number: 324925  Size: SH

    Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

       • Air bag deployment
       • Personal injury
       • Unnecessary SIR system repairs
    In order to avoid the above conditions, observe the following guidelines:
       • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
       • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

  1. Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
  2. Remove the turn signal and multifunction switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle .
  3. Remove the turn signal switch housing. Refer to Turn Signal Switch Housing - Disassemble - Off Vehicle .
  4. If column shift, remove the shift lever. Refer to Shift Lever - Disassemble - Off Vehicle .
  5. Remove the tilt spring assembly. Refer to Tilt Spring - Disassemble - Off Vehicle .
  6. If column shift, remove the linear shift assembly. Refer to Linear Shift Assembly - Disassemble - Off Vehicle .
  7. Remove the steering shaft seal (6).
  8. Remove the sensor retainer (5).
  9. Remove the lower spring retainer (4).
  10. Remove the lower bearing spring (3).
  11. Remove the lower bearing seat (2).
  12. Remove the adapter and bearing assembly (1).

  13. Object Number: 372071  Size: SH
  14. Remove the 2 pivot pins from the steering column support assembly with J 21854-01 .

  15. Object Number: 324937  Size: SH
  16. Install the tilt lever and tilt the column to the upright position.
  17. Remove the upper tilt head assembly with the steering shaft assembly.

  18. Object Number: 324936  Size: SH
  19. Remove the steering shaft assembly (1).

  20. Object Number: 295954  Size: SH

    Important: Mark the race and upper shaft assembly and the lower steering shaft assembly to ensure proper assembly. Failure to assemble properly will cause the steering wheel to be turned 180 degrees.

  21. Tilt the race and upper shaft assembly 90 degrees to the lower steering shaft assembly and disengage.

  22. Object Number: 299877  Size: SH
  23. Remove the 4 TORX® head screws (2) and discard from the steering column support assembly (1).
  24. Remove the steering column support assembly (1) from the steering column jacket (3).