Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls-3.4L or Air Cleaner Assembly Replacement in Engine Controls-3.8L.



3. Remove the suction hose nut at the accumulator and position the suction hose aside .



4. Remove the A/C compressor hose nut from the accumulator and position the A/C compressor hose aside.



5. Remove the accumulator bracket bolt.
6. Remove the accumulator.

1. Install the accumulator.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the accumulator bracket bolt.

Tighten
Tighten the bolt to 4 N·m (36 lb in).

3. Install new O-ring seals onto the A/C compressor hose and the suction hose. Refer to O-Ring Replacement .



4. Install the A/C compressor hose to the accumulator.
5. Install the A/C compressor hose nut to the accumulator.

Tighten
Tighten the nut to 16 N·m (12 lb ft).




6. Connect the suction hose to the accumulator
7. Tighten the suction hose nut.

Tighten
Tighten the nut to 47 N·m (35 lb ft).

8. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls-3.4L or Air Cleaner Assembly Replacement in Engine Controls-3.8L.
9. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
10. Leak test the fittings of the component using J 39400-A .