GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Impala 🢒 Body and Accessories 🢒 Body Control System 🢒 DTC B1349

Circuit Description

The BCM ground circuits provide ground for the 2 Theater Dimming systems for interior lamps, BTSI solenoid, BCM electronics and the door locks.

Conditions for Running the DTC

The BCM Electronics ground must be connected to ground.

Conditions for Setting the DTC

The BCM detects that any of its ground circuits are greater than 4 volts for longer than 300 milliseconds.

Action Taken When the DTC Sets
    • The interior lamps do not function correctly.
    • The brake-transmission safety interlock may not function correctly.
    • The door lock features may not operate correctly,
    • The BCM stores DTC B1349 in memory.

Conditions for Clearing the DTC
    • A current DTC clears when the malfunction is no longer present.
    • A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Test Description

The number below refer to the step number on the diagnostic table.

  1. This step checks for an open in the ground circuits.

Step

Action

Yes

No

Schematic Reference: Body Control System Schematics

1

Did you perform the Diagnostic System Check for the system in which the symptom appeared?

Go to Step 2

Go to the appropriate Diagnostic System Check for the symptom

2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, observe the following parameters in the BCM input data list.
    4. • Theater Dim 1 Ground
    • Theater Dim 2 Ground
    • Doors System Gnd
    • Loads System Gnd
    • Electronic System Gnd

Does the scan tool display Active for all 5 parameters?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

Test the ground circuit that does not display Active in the previous step for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 6

Go to Step 4

4

Inspect for poor connections at the harness connector of the Body Control Module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 6

Go to Step 5

5

Important:: Perform the Set up New Body Control Module procedure. Refer to Body Control Module (BCM) Programming/RPO Configuration .

Replace the Body Control Module. Refer to Body Control Module Replacement .

Did you complete the repair?

Go to Step 6

--

6
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK