GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Impala 🢒 Engine 🢒 Engine Electrical 🢒 Throttle Body Assembly Replacement

Removal Procedure

    Object Number: 69056 Size: SH
  1. Drain the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.
  2. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
  3. Disconnect the idle air control (IAC) valve electrical connector.

    4. Object Number: 69065 Size: SH
  4. Disconnect the throttle position (TP) sensor electrical connector.
  5. Remove the accelerator controls cable bracket. Refer to Accelerator Control Cable Bracket Replacement

    6. Object Number: 622761 Size: SH
  6. Remove the throttle body inlet (3) and the outlet (4) hoses from the throttle body.

    7. Object Number: 54419 Size: SH
  7. Remove the heater pipe nut at the throttle body.

    8. Object Number: 12688 Size: SH
  8. Remove the nuts and the bolts from the throttle body.
  9. Remove the throttle body assembly.
  10. Remove the throttle body gasket.

    11. Notice: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

    Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as sharp tools may damage the gasket surfaces.

  11. Clean and inspect the throttle body gasket mating surfaces.

Installation Procedure

    Object Number: 12688 Size: SH
  1. Install a new gasket, if necessary.
  2. Install the throttle body assembly.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the throttle body nuts and the bolts.

    4. Tighten
    Tighten the nuts and the bolts to 28 N·m (21 lb ft).


    Object Number: 622761 Size: SH
  4. Install the inlet (3) and the outlet (4) hoses to the throttle body.

    5. Object Number: 54419 Size: SH
  5. Install the heater pipe nut to the throttle body.

    6. Tighten
    Tighten the nut to 25 N·m (18 lb ft).


    Object Number: 69065 Size: SH
  6. Connect the TP sensor electrical connector.

    7. Object Number: 69056 Size: SH
  7. Connect the IAC valve electrical connector.
  8. Install the accelerator controls cable bracket. Refer to Accelerator Control Cable Bracket Replacement .
  9. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
  10. Fill the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.