GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Impala 🢒 HVAC 🢒 Heating, Ventilation and Air Conditioning 🢒 Blower Motor Resistor Assembly Replacement

Removal Procedure
  1. Remove the right side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages and Console.

    2. Object Number: 295302 Size: SH
  2. Disconnect the electrical connector from the blower motor resistor.

    3. Object Number: 295327 Size: SH
  3. Disconnect the electrical connector from the blower motor.

    4. Important: The blower motor resistor opening is slotted. Access is extremely limited.


    Object Number: 295304 Size: SH
  4. Loosen both screws to the forward blower motor resistor.
  5. Remove the rear screw to the blower motor resistor.
  6. Remove the blower motor resistor.

Installation Procedure

    Object Number: 295304 Size: SH

    Important: Align the blower motor control processor forward retaining slots onto screws and seat the blower motor control processor against the HVAC module.

  1. Install the blower motor resistor.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the rear screw to the blower motor resistor.

    3. Tighten
    Tighten all screws to 1.5 N·m (13 lb in).


    Object Number: 295327 Size: SH
  3. Connect the electrical connector to the blower motor.

    4. Object Number: 295302 Size: SH
  4. Connect the electrical connector to the blower motor resistor.
  5. Install the right side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages and Console.