For 1990-2009 cars only
Removal Procedure
- Disconnect the intake air temperature (IAT) sensor electrical connector (3).
- Remove the positive crankcase ventilation (PCV) tube (4) from the air cleaner intake duct.
- Disconnect the mass air flow (MAF) sensor electrical connector (5).
- Loosen the air cleaner intake duct hose clamp (2).
- Remove the air cleaner intake duct from the throttle body.
- Unclip the 2 air cleaner cover clips.
- Remove the air cleaner cover (5) with the air cleaner intake duct.
- Remove the air cleaner element (6) from the air cleaner assembly (1).
Installation Procedure
- Install the air cleaner element (6) to the air cleaner assembly (1).
- Install the air cleaner cover (5) with the air cleaner intake duct.
- Install the 2 air cleaner cover clips.
- Install the air cleaner intake duct to the throttle body.
- Tighten the air cleaner intake duct clamp (2).
- Connect the MAF sensor electrical connector (5).
- Install the PCV tube (4) to the air cleaner intake duct.
- Connect the IAT sensor electrical connector (3).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the clamp to 2 N·m (18 lb in).
