GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Impala 🢒 Engine 🢒 Engine Mechanical - 3.4L 🢒 Oil Filter Adapter and Bypass Valve Assembly Replacement

Removal Procedure

    Object Number: 190543 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the oil filter. Refer to Engine Oil and Oil Filter Replacement .

    3. Object Number: 96347 Size: SH
  3. Remove the oil filter bypass hole plug.

    4. Object Number: 96363 Size: SH

    Important: Do not pry against the threads in the oil filter bypass hose when removing the bypass valve.

  4. Insert a flat bladed tool into the oil filter bypass hole and remove the bypass valve.

    5. Object Number: 96355 Size: SH
  5. If necessary, remove the oil filter fitting.

Installation Procedure

    Object Number: 96355 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the oil filter fitting.

    2. Tighten
    Tighten the fitting to 39 N·m (29 lb ft).


    Object Number: 190505 Size: SH
  2. Install the oil filter bypass valve (1) to the proper depth.

    3. Object Number: 96347 Size: SH
  3. Install the oil filter bypass hole plug.

    4. Tighten
    Tighten the plug to 19 N·m (14 lb ft).


    Object Number: 190543 Size: SH
  4. Install the oil filter.
  5. Lower the vehicle.
  6. Check and fill the crankcase as necessary. Refer to Engine Oil and Oil Filter Replacement .