Schematic Reference: Power Window Schematics

Connector End View Reference: Power Door Systems Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Verify that the inoperative power windows lockout function fault is present.

Does the power windows lockout function operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Disconnect the driver window switch.
2. Turn ON the ignition, with the engine OFF.
3. Using a test lamp connected to ground, probe the power window master switch lockout signal circuit of the driver window switch with a test lamp that is connected to ground.

Does the test lamp illuminate?

Go to Step 4

Go to Step 5

Repair the short to battery positive voltage in the power window master switch lockout signal circuit. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 7

--

Inspect for poor connections at the harness connector of the driver window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 6

Replace the driver window switch. Refer to Front Side Door Window Switch Replacement .

Did you complete the replacement?

Go to Step 7

--

Operate the system in order to verify the repair.

Did you find and correct the condition?

System OK

Go to Step 2