Schematic Reference: Instrument Cluster Schematics

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With the scan tool, perform the Coolant Gage Sweep Test.

Does the engine coolant temperature gage move up and down when commanded?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 4

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2