Schematic Reference: Exterior Lights Schematics

Connector End View Reference: Master Electrical Component List in Wiring Systems

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Turn the ignition to the ON position.
2. Place the hazard lamp switch to the ON position.

Do all of the turn signal tamps flash ON and OFF?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Disconnect the hazard switch.
2. Using a test lamp connected to ground, probe the HAZ SW fuse battery positive voltage circuit.

Does the test lamp illuminate?

Go to Step 5

Go to Step 4

Repair a high resistance, open or short to ground in the HAZ SW fuse battery positive voltage circuit. Refer to Wiring Repairs and to Connector Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 6

--

Replace the hazard switch. Refer to Hazard Warning Switch Replacement .

Did you complete the replacement?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2