Removal Procedure
Important: There are several types of plastic fuel and
evaporative emission (EVAP) quick connect fittings used on this vehicle. The following
instructions apply to all types of plastic quick connect fittings except where indicated.
- Relieve the fuel system pressure. Refer to
Fuel Pressure Relief .
Caution: Wear safety glasses when using compressed air, as flying dirt particles
may cause eye injury.
- Use compressed air, blow and dirt or debris from
around the quick-connect fitting.
- Squeeze the plastic quick connect fitting release tabs
together to disengage the quick connect fitting. (This step applies to Bartholomew
style fittings ONLY).
- Squeeze where indicated by the arrows on both sides
of the plastic ring to disengage the quick connect fitting.
- Squeeze where indicated by the arrows on both sides
of the plastic ring to disengage the quick connect fitting.
- Pull the quick connect fitting connection apart.
Installation Procedure
Caution: In order to reduce the risk of fire and personal injury, before connecting
fuel pipe fittings, always apply a few drops of clean engine oil to the male
pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector
will swell and may prevent proper reconnection if not lubricated.
- Apply a few drops of clean oil to the male connection
end.
- Push both sides of the quick-connect fitting together
in order to cause the retaining tabs to snap into place.
- Once installed, pull on both sides of the quick connect
fittings in order to ensure that the connection is secure.