The body control module (BCM) controls the hazard lamps based on inputs from the hazard switch. With the hazard switch closed, a ground path is provided on the hazards switch signal circuit, indicating a hazard lamp request. When this request is seen, the BCM will pulse the turn signal lamp supply voltage circuits, illuminating the turn signal lamps.

Schematic Reference

Exterior Lights Schematics

Connector End View Reference

Lighting Systems Connector End Views

Description and Operation

Exterior Lighting Systems Description and Operation

Electrical Information Reference

Scan Tool Reference

1. Ignition ON, individually operate both the left and right turn signals. All applicable lamps should flash when in each turn signal position.

⇒	If any of the lamps do not flash, refer to Turn Signal Lamps and/or Indicators Malfunction .

2. Observe the scan tool Hazard Lamp Switch parameter while cycling the hazard switch. The parameter should change between Active and Inactive.

⇒	If the parameter does not cycle between the specified values, refer to Hazard Switch Circuit Malfunction.

3. Press the hazard switch. All applicable lamps should flash.

⇒	If one or more lamps do not flash, replace the BCM.

Hazard Switch Circuit Malfunction

1. Ignition OFF, disconnect the harness connector C1 at the turn signal/multifunction switch.
2. Test for less than 5.0 ohms of resistance between the ground circuit terminal H and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify the scan tool Hazard Lamp Switch parameter is Inactive.

⇒	If not the specified value, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the BCM.

4. Install a 3A fused jumper wire between the signal circuit terminal C and the ground circuit terminal E. Verify the scan tool Hazard Lamp Switch parameter is Active.

⇒	If not the specified value, test the signal circuit for a short to voltage or and open/high resistance. If the circuit tests normal, replace the BCM.

5. If all circuits test normal, test or replace the turn signal/multifunction switch.

Turn Signal/Multifunction Switch

1. Ignition OFF, disconnect the harness connector C1 at the turn signal/multifunction switch.
2. Test for infinite resistance between the signal circuit terminal C and the ground circuit terminal H with the switch in the open position.

⇒	If not the specified value, replace the turn signal/multifunction switch.

3. Test for less than 2.0 ohms of resistance between the signal circuit terminal C and the ground circuit terminal H with the switch in the closed position.

⇒	If greater than the specified range, replace the turn signal/multifunction switch.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.