Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Remove the right front wheelhouse panel liner. Refer to Front Fender Liner Replacement .
2. Disconnect the electrical connector from the windshield washer solvent level sensor switch.
3. Disconnect the electrical connector at the windshield washer pump.
4. Lower the vehicle.
5. Remove the screw from the filler neck at the RF fender flange.
6. Remove the washer solvent container filler cap.

1

Windshield Washer Solvent Container Bolts (Qty: 2)

Tighten
6 N·m (53 lb in)

Tip
Transfer the cap and lower mounting bracket on the container to the new washer solvent container.

2

Windshield Washer Pump Hose Assembly

Tip
Disconnect the hose from the windshield washer pump spout and drain washer solvent into a suitable clean container.

3

Windshield Washer Level Sensor Switch

4

Windshield Washer Pump

Tip
Discard old grommet and replace with a new grommet. Transfer the old pump to the new container.

5

Windshield Washer Container Assembly

Tip
Lower the windshield washer container from RH chassis rail in between the RF fender bracket and bumper fascia.