Preliminary Procedures

1. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
2. Remove the rear door inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement .
3. Remove the rear door outer belt sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement .

1

Rear Side Door Window Weatherstrip Bolt

Notice: Refer to Fastener Notice in the Preface section.

Procedure

1. Apply masking tape to the door frame and applique.
2. Remove the rear door water deflector.
3. Position the window to the full down position.

Tighten
10 N·m (89 lb in)

2

Rear Side Door Window Weatherstrip Rivet (Qty: 6)

Procedure

1. Remove the window weatherstrip by grasping the center and pulling downward to expose the rivets.
2. Drill out the 4 mm (5/32 in) rivets (1) along the inside edge of the rear side door window weatherstrip (3) retainer.

3

Rear Side Door Window Weatherstrip

Procedure

1. Removing the weatherstrip starting at the rear lower end, pull the inner window weatherstrip away from the door frame.
2. Install the weatherstrip at the upper, rear corner, install the inner window weatherstrip to the door pinchweld flange.
3. Install the window channel weatherstrip by working it around the door frame. Ensure that the weatherstrip is fully seated into the window channel retainer.
4. Inspect the window for proper operation.