Quarter Window Replacement Impala

Tools Required

Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.

1. Remove the rear quarter upper trim. Refer to Quarter Upper Trim Panel Replacement.
2. Remove the rear quarter lower trim. Refer to Quarter Lower Rear Trim Panel Replacement.

Caution: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

3. Cover to protect the following parts from broken glass:

•	Upper dash pad

•	Defroster outlets and A/C outlets

•	Seats and carpeting





Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

Important: Keep the cutting edge of the tool against the window. Do this from inside the vehicle to protect the outer painted surface.

4. This will allow the urethane adhesive to be separated from the window.

•	Leave a base of urethane on the pinch-weld flange.

•	The only suitable lubrication is clear water.

•	Use J 39032 or equivalent in order to remove the window.

•	Remove the quarter modular window from the pinch-weld flange.

1. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows.
2. Install the rear quarter lower trim. Refer to Quarter Lower Rear Trim Panel Replacement.
3. Install the rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement.
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

Quarter Window Replacement Monte Carlo

Tools Required

Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.

1. Remove the rear quarter upper trim. Refer to Quarter Upper Trim Panel Replacement.
2. Remove the rear quarter lower trim. Refer to Quarter Lower Rear Trim Panel Replacement.

Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

Important: Keep the cutting edge of the tool against the window. Do this from inside the vehicle to protect the outer painted surface.

3. This will allow the urethane adhesive to be separated from the window.

•	Leave a base of urethane on the pinch-weld flange.

•	The only suitable lubrication is clear water.

•	Use J 39032 or equivalent in order to remove the window.

•	Remove the quarter modular window from the pinch-weld flange.

1. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows .
2. Install the rear quarter lower trim. Refer to Quarter Lower Rear Trim Panel Replacement.
3. Install the rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement.
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.