Windshield Wiper System Module Replacement. Chevrolet Impala 2007

GM Service Manual Online

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2007 🢒 Impala 🢒 Preface 🢒 Cautions and Notices 🢒 Windshield Wiper System Module Replacement

Windshield Wiper System Module Replacement Impala

Object Number: 1596305 Size: SF

Callout	Component Name
Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the wiper arms. Refer to Windshield Wiper Arm Replacement . Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .
1	Bolt, Windshield Wiper Module Important: Tighten bolts in sequence as shown upon installation. Tighten 9 N·m (80 lb in)
2	Bolt, Windshield Wiper Module Tighten 9 N·m (80 lb in)
3	Bolt, Windshield Wiper Module Tighten 9 N·m (80 lb in)
4	Module Assembly, Windshield Washer System Raise the forward edge of the windshield washer module assembly out of the plenum panel first followed by disconnecting the wiper motor electrical connector. Upon installation of the windshield washer module, turn the module 180 degrees, slide the module under the hood and align the rear locator to the backside of the plenum. Tighten the bolts in sequence as shown.
5	Connector, Windshield Wiper Motor Tip Connect the electrical connector to the wiper motor prior to installing the module assembly back into the plenum.

Windshield Wiper System Module Replacement Monte Carlo

Object Number: 1596304 Size: SF

Callout	Component Name
Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the wiper arms. Refer to Windshield Wiper Arm Replacement . Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .
1	Windshield Wiper Module Bolt Tip Tighten bolts in sequence to the specified torque value. Tighten 9 N·m (80 lb in)
2	Windshield Wiper Module Bolt Tighten 9 N·m (80 lb in)
3	Windshield Wiper Module Bolt Tighten 9 N·m (80 lb in)
4	Module Assembly, Windshield Washer System Raise the forward edge of the windshield washer module assembly out of the plenum panel first followed by disconnecting the wiper motor electrical connector. Upon installation of the windshield washer module, turn the module 180 degrees, slide the module under the hood and align the rear locator to the backside of the plenum. Tighten the bolts in sequence as shown.
5	Windshield Wiper Motor Electrical Connector Tip Connect the electrical connector to the wiper motor prior to installing the module assembly back into the plenum.