Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Open the rear compartment lid.
2. Remove the nut securing the rear compartment trim the backside of the tail lamp assembly.
3. Pull down the rear compartment trim liner.

1

Nuts, Tail Lamp Assembly (Qty: 2)

Tighten
2 N·m (18 lb in)

2

Nut, Trunk Trim Liner

Tip
Ensure the trim liner nut is installed after the liner is repositioned in the rear compartment.

3

Lamp Assembly, Tail

Tip
Pull rearward to remove and connect the electrical connector and push lamp inward in order to position the lamp to the body panel.

4

Connector, Rear Lamp Harness

Ensure to connect the lamp harness connector before securing the lamp to the rear body panel.