Caution: Refer to SIR Caution in the Preface section.

Caution: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.

Caution: When carrying an undeployed inflatable restraint seat belt pretensioner:

Preliminary Procedures

1. Move the front seat all the way forward.
2. Disable the SIR. Refer to SIR Disabling and Enabling.
3. Remove the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement.
4. Remove the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement.

1

Belt Tensioner (Retractor Side) Bolt/Screw

Procedure

1. Unsnap the upper sleeve from the linkage cover and slide down.
2. Remove the linkage screw and pull the linkage plate from the linkage covers.
3. After loosening the screw, push the screw through the hole using the small access hole on the opposite side of the linkage cover.
4. If the screw does not come out, the cover halves can be separated with a flat-head screwdriver to access and hold the nut.

2

Pretensioner Cover

3

Seat Shoulder Belt Anchor Nut

Notice: Refer to Fastener Notice in the Preface section.

Tighten
42 N·m (31 lb ft)

4

Seat Belt (Retractor Side) Tensioner Assembly

5

Seat Shoulder Belt Guide Cover

6

Seat Shoulder Belt Guide Bolt

Tighten
42 N·m (31 lb ft)

7

Seat Shoulder Belt Retractor Bolt

Tighten
68 N·m (50 lb ft)

8

Seat Shoulder Belt Retractor