Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

1

Screws, Rear License Plate Lamp (Qty: 2)

Tighten
2 N·m (18 lb in)

2

Lamp, Rear License

Tip

1. Pull downward on the lamp in order to access the lamp electrical connector on the inside of the rear bumper fascia.
2. Twist the connector socket counterclockwise in order to remove from the lamp housing.
3. Pull the bulb outward to remove from the socket.

3

Lens, Rear License Plate

Tip
Snap lens into outer rear compartment lid upon installation.