Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Preliminary Procedures

1. Turn the ignition switch to the OFF position.
2. If equipped with the 3.5L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
3. If equipped with the 3.9L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
4. If equipped with the 5.3L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
5. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area and the brake pipe fitting areas of any accumulated dirt and foreign material.

1

EBCM Electrical Connector

2

Brake Pipe Fitting (Qty: 6)

Notice: Refer to Fastener Notice in the Preface section.

Tip

Tighten
24 N·m (18 lb ft)

3

EBCM Mounting Bolt

Tighten
10 N·m (89 lb in)

4

Brake Pressure Modulator Valve (BPMV)

Tip