For 1990-2009 cars only
Removal Procedure
- Using a bent-tip screwdriver or equivalent, pull on one of the open ends of the retaining ring in order to rotate the retaining ring.
- Rotate the retaining ring around the quick connector until the retaining ring is out of position and can be completely removed.
- Remove the engine oil cooler line from the quick connector fitting.
- Clean all of the components in a suitable solvent, and dry them with compressed air.
- Inspect the fittings, the connectors, the cooler lines, and the cooler for damage, distortion, or restriction. Replace parts as necessary.
Pull the lines straight out from the connector.
Installation Procedure
- Install the retaining ring into each quick connector fitting.
- Hook one of the open ends of the retaining ring in one of the slots in the quick connector.
- Rotate the retaining ring around the connector until the retaining ring is positioned with all 3 ears through the 3 slots.
- Ensure the 3 retaining ring ears can be seen from the inside of the connector and the retaining ring can move freely in the slots.
- Install the engine oil cooler line into the quick connector fitting.
- Inspect and fill the engine oil to the proper level.
Important: Do not install the new retaining ring onto the fitting by pushing the retaining ring down over the fitting.
Pull back on the engine oil cooler lines to ensure a proper connection.
