Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Remove the front seat. Refer to Front Seat Replacement - Bucket .
2. Remove the lumbar actuator knob. Refer to Lumbar Support Knob Replacement .
3. Remove the recliner handle. Refer to Driver Seat and Passenger Seat Recliner Handle Replacement .
4. Remove the power seat switch knob. Refer to Driver Seat and Passenger Seat Adjuster Switch Knob Replacement .
5. Remove the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .

1

Cover, Seat Cushion

Refer to Front Seat Cushion Cover and Pad Replacement .

2

Pad, Seat Cushion

Refer to Front Seat Cushion Cover and Pad Replacement .

3

Bolt, Front Seat Cushion Frame (Qty: 4)

Tighten
45 N·m (33 lb ft)

4

Nut, Front Seat Cushion Frame (Qty: 4)

Tighten
9 N·m (80 lb in)

5

Reinforcement, Seat Cushion Frame Rear

6

Frame, Front Seat Cushion

Tip

1. Remove the heated seat module, if equipped. Refer to Front Seat Heater Control Module Replacement .
2. Remove the inflatable restraint passenger presence system if working on the passenger seat. Refer to Inflatable Restraint Passenger Presence System Replacement - Front .
3. Disconnect the wiring harness from the seat cushion.
4. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .