Removal Procedure
- Disconnect the positive crankcase ventilation (PCV) tube from the air inlet duct. Refer to
Plastic Collar Quick Connect Fitting Service.
- Loosen the air inlet duct clamp at the throttle body.
- Remove the air inlet duct from the throttle body.
- Loosen the air inlet duct clamp at the mass air flow (MAF)/intake air temperature (IAT) sensor.
- Remove the air inlet duct from the MAF/IAT sensor.
Installation Procedure
- Install the air inlet duct from the MAF/IAT sensor.
Caution: Refer to Fastener Caution in the Preface section.
- Tighten the air inlet duct clamp at the MAF/IAT sensor.
Tighten
Tighten the clamp to 3 N·m (27 lb in).
- Install the air inlet duct to the throttle body.
- Tighten the air inlet duct clamp at the throttle body.
Tighten
Tighten the clamp to 3 N·m (27 lb in).
- Connect the PCV tube to the air inlet duct. Refer to
Plastic Collar Quick Connect Fitting Service.