Removal Procedure
Warning: Failure to disconnect intermediate shaft from rack and pinion stub shaft can result in damage to steering gear and/or intermediate shaft. This damage can cause loss of steering control which could
result in personal injury.
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the left tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation.
- Remove the pinch bolt from the lower intermediate steering shaft. Refer to
Intermediate Steering Shaft Replacement.
- Loosen all insulator clamp attaching bolts.
- Place a jackstand under the center of the rear frame crossmember.
- Remove the rear frame-to-body bolts.
- Lower the rear of the frame just enough to gain access to the stabilizer shaft.
- Remove the insulator clamp bolts and the clamps from the frame.
- Remove the insulators from the stabilizer bar.
- Remove the stabilizer bar links from the control arms. Refer to
Stabilizer Shaft Link Replacement.
- Pull the stabilizer shaft rearward.
- Swing the stabilizer shaft down to remove the stabilizer shaft from the left side of the vehicle.
Installation Procedure
Warning: When installing the intermediate shaft make sure that the shaft is seated prior to pinch bolt installation. If the pinch bolt is inserted into the coupling before shaft installation, the two mating
shafts may disengage. Disengagement of the two mating shafts will cause loss of steering control which could result in personal injury.
- Insert the stabilizer shaft to the left side of the vehicle.
Note: DO NOT tighten the stabilizer link nut at this time. The weight of the vehicle must be supported by the control arms such that you can obtain the vehicle design trim heights before tightening the link nut.
- Loosely install the stabilizer shaft link at the control arm.
- Install the insulators on to the stabilizer bar.
Caution: Refer to Fastener Caution in the Preface section.
- Connect the insulator clamps to the frame.
Tighten
Tighten the stabilizer shaft bracket bolt to 42 N·m (31 lb ft).
- Raise the frame into position while you guide the steering shaft onto the gear.
- Install the rear frame-to-body attaching bolts.
Tighten
Tighten the frame to body attaching bolts to 160 N·m (118 lb ft).
- Remove the jackstand.
- Install the pinch bolt and tighten. Refer to
Intermediate Steering Shaft Replacement.
- Install the left tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation.
- Lower the vehicle.
- Support the weight of the vehicle by the control arms.
- Tighten the stabilizer link nut.
Tighten
Tighten the stabilizer shaft link nut to 23 N·m (17 lb ft).