Special Tools
• | EN-47823 Valve Spring Compressor Adapter |
• | J-5892-D Valve Spring Compressor |
Note: Use oversize valve stem seals if you install oversize valves.
- Lubricate the valve stem with clean engine oil.
- Install the valves.
- Lightly tap the new or reconditioned valves into the valve seat.
- Install the valve stem oil seals, ensuring proper intake - black seal and exhaust - brown seal, seals are installed.
- Install the valve springs.
- Install the valve spring caps.
- Using caution so as not to damage the valve spring or valve spring dampener, compress the valve springs using the
J-5892-D Valve Spring Compressor
(1) and
the
EN-47823 Valve Spring Compressor Adapter
(2).
- Install the valve spring cap keys. Hold the valves in place with grease, if necessary.
- Release the valve springs.
- Ensure that the valve locks are seated.
- Apply sealer P/N 21485278 to the coolant temperature sensor.
Caution: Refer to Fastener Caution in the Preface section.
- Install the coolant temperature sensor, if required, and tighten to
23 N·m (17 lb ft).
- Install the heater inlet pipe stud, if required, and tighten to
35 N·m (26 lb ft).