GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Impala 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Battery Current Sensor Replacement

Battery Current Sensor Replacement RPO LS4

Removal Procedure

    Object Number: 1616995 Size: SH
  1. Disconnect the instrument panel (I/P) harness electrical connector (2) from the battery current sensor.
  2. Remove the positive and negative battery cable. Refer to Battery Positive and Negative Cable Replacement .

    3. Object Number: 1617007 Size: SH
  3. Cut the tie straps and electrical tape attaching the battery current sensor to the positive battery cable.
  4. Squeeze the battery cable branches together.

    5. Important: Note the position of the battery current sensor prior to removal.

  5. Slide the battery current sensor (1) off of the battery cable.

Installation Procedure

    Object Number: 1617007 Size: SH

    Important: Ensure that the tape tab is pointing away from the battery prior to installation.

  1. Slide the NEW battery current sensor (1) up onto the battery cable.
  2. Using NEW tie straps and electrical tape, attach the battery current sensor to the positive battery cable.

    3. Object Number: 1616995 Size: SH
  3. Install the positive and negative battery cable. Refer to Battery Positive and Negative Cable Replacement .
  4. Connect the I/P harness electrical connector (2) to the battery current sensor.

Battery Current Sensor Replacement RPOs LZE/LZ4/LZ8

Removal Procedure

    Object Number: 1616991 Size: SH
  1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
  2. Remove the positive and negative battery cable. Refer to Battery Positive and Negative Cable Replacement .

    3. Object Number: 1617003 Size: SH
  3. Cut the tie straps and electrical tape attaching the battery current sensor to the positive battery cable.
  4. Squeeze the positive and negative battery cable branches together.

    5. Important: Note the position of the battery current sensor prior to removal.

  5. Slide the battery current sensor (1) off of the battery cable.

Installation Procedure

    Object Number: 1617003 Size: SH

    Important: Ensure that the tape tab is pointing towards the positive battery terminal prior to installation.

  1. Slide the NEW battery current sensor (1) up onto the battery cable.
  2. Using NEW tie straps and electrical tape, attach the battery current sensor to the positive battery cable.

    3. Object Number: 1616991 Size: SH
  3. Install the positive and negative battery cable. Refer to Battery Positive and Negative Cable Replacement .
  4. Connect the I/P harness electrical connector (1) to the battery current sensor.