Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Disconnect the right knock sensor electrical connector (2).
- Loosen and remove the knock sensor.
Installation Procedure
Caution: Refer to Fastener Caution in the Preface section.
Note: DO NOT apply thread sealant to the sensor threads. The sensor threads are coated at the factory. Applying additional sealant affects the sensors ability to detect detonation.
- Install and tighten the knock sensor.
Tighten
Tighten the sensor to 25 N·m (18 lb ft).
- Connect the right knock sensor electrical connector (2).
- Lower the vehicle.