GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Traction Control Switch Signal

1

1

--

--

Ground

--

1

--

--

1. Traction Control Indicator Malfunction

Circuit Description

The instrument panel cluster (IPC) momentarily illuminates the StabiliTrak indicator during the IPC bulb check. When a fault affecting the stabilitrak system is detected, the warning indicator is illuminated.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

  1. Ignition ON, with a scan tool command the IPC display test ON and OFF. The StabiliTrak indicator should turn ON and OFF.
  2. If the indicator does not turn ON and OFF, replace the IPC.
  3. Observe the scan tool BCM Traction Control Switch parameter while pressing and releasing the traction control switch. The reading should change between Active and Inactive.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the traction control switch.
  2. Test for less than 1 ohm between the ground circuit terminal below and ground.
  3. If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Ignition ON, verify the scan tool BCM Traction Control Switch parameter is Inactive.
  5. If not the specified value, test the signal circuit terminal for a short to ground. If the circuit tests normal, replace the BCM.
  6. Install a 3A fused jumper wire between the signal circuit terminal and the ground circuit terminal. Verify the scan tool BCM Traction Control Switch parameter is Active.
  7. If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  8. If all circuits test normal, test or replace the traction control switch.

Component Testing

  1. Ignition OFF, disconnect the harness connector at the traction control switch.
  2. Test for infinite resistance between the signal terminal and the ground terminal with the switch in the open position.
  3. If not the specified value, replace the traction control switch.
  4. Test for less than 3 ohms between the signal terminal and the ground terminal with the switch in the closed position.
  5. If greater than the specified range, replace the traction control switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Electronic Traction Control Switch Replacement
    •  Control Module References for BCM or IPC replacement, setup, and programming