GM Service Manual Online
For 1990-2009 cars only

Special Tools

J 24319-B Universal Steering Linkage Puller

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

  3. Object Number: 575833  Size: SH
  4. Remove the prevailing torque nut (2) from the outer tie rod assembly (1).

  5. Object Number: 297349  Size: SH
  6. Loosen the jam nut (2) on the inner tie rod assembly (1).
  7. Caution: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.


    Object Number: 643351  Size: SH
  8. Remove the outer tie rod assembly from the steering knuckle using J 24319-B .

  9. Object Number: 297358  Size: SH
  10. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

Installation Procedure


    Object Number: 297355  Size: SH
  1. Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).

  2. Object Number: 297628  Size: SH
  3. Install the outer tie rod assembly (2) to the steering knuckle (1).
  4. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 575833  Size: SH
  5. Install the prevailing torque nut (2) to the outer tie rod assembly (1).
  6. Tighten
    Tighten the nut to 30 N·m (22 lb ft) plus 120 degrees. Visually inspect to ensure that 2 ½ to 4 ½ threads are visible past the nylon washer.


    Object Number: 297355  Size: SH
  7. Install tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  8. Lower the vehicle.
  9. Perform a front end alignment. Refer to Wheel Alignment Measurement.