GM Service Manual Online
For 1990-2009 cars only

Object Number: 1829288  Size: MF

Callout

Component Name

Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Preliminary Procedures

  1. Turn the ignition switch to the OFF position.
  2. If equipped with the 3.5L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement.
  3. If equipped with the 3.9L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement.
  4. If equipped with the 5.3L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement.
  5. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area and the brake pipe fitting areas of any accumulated dirt and foreign material.

1

EBCM Electrical Connector

2

Brake Pipe Fitting (Qty: 6)

Caution: Refer to Fastener Caution in the Preface section.

Tip

    • Note the location and routing of the brake pipes as an aid to installation.
    • Cap the brake pipe fittings and plug the brake pressure modulator inlet/outlet ports to prevent brake fluid loss and contamination.

Tighten
24 N·m (18 lb ft)

3

EBCM Mounting Bolt

Tighten
10 N·m (89 lb in)

4

Brake Pressure Modulator Valve (BPMV)

Tip

    • If necessary, remove the EBCM. Refer to Electronic Brake Control Module Replacement.
    • Bleed the antilock brake system. Refer to Antilock Brake System Automated Bleed Procedure.