Accumulator Assembly, 2-1 Band Servo Assemble for Chevrolet Impala 2009

1. Install the 2-1 manual band servo cover seal (105) into the case. Lubricate the 2-1 manual band servo cover seal (105) with automatic transmission fluid.

Caution: Do not damage the 2-1 manual band servo exhaust screen on installation.

2. Install the 2-1 manual band servo assembly (106-116) into the case. Make sure that the 2-1 manual band servo pin engages the 2-1 manual band assembly.



3. Install the accumulator (132-140) and 2-1 manual band servo cover assembly (104) into the case.
4. Install the lube oil pipe and washer assembly (130) through the case and into the lube hole in the differential carrier internal gear.
5. Use a screwdriver in order to lock the lube oil pipe retainer (129) into the case.

Caution: Refer to Fastener Caution in the Preface section.

6. Install the three 2-1 manual band servo cover bolts (103) and tighten to 25 N·m (18 lb ft).
7. Install the four accumulator cover bolts (131) and tighten to 12 N·m (106 lb in).