Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Use a J 25070 Heat Gun in a circular motion to warm the roof ditch molding prior to removal. Carefully clean the roof panel ditch thoroughly prior to bonding the new ditch molding to the roof panel.

1

Molding Assembly, Roof Ditch

Tip

1. Upon installation of the new ditch molding, engage the front edge of the molding into the clip at the front roof header.
2. Remove the protective liner from the backside of the molding adhesive tape surface.
3. Ensure full adhesion of the ditch molding to the roof using the palm of the hand with a dry towel or a roller type tool working from the front of the vehicle to the rear.
4. Engage the rear end of the molding to the retainer clip in the roof ditch.

2

Molding Assembly, Roof Ditch