Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

Preliminary Procedure

Use a J 25070 Heat Gun in a circular motion to warm the door bodyside molding prior to removal. Carefully clean the body panel thoroughly prior to bonding the new bodyside molding to the door.

1

Molding Asm, Bodyside Door

Tip:

1. Upon installation of the new rear door molding, position the pin on the frontside of the molding to the round hole first at the front edge of the door then to the oval holes.
2. Remove the protective liner from the backside of the molding adhesive tape.
3. Ensure full adhesion of the molding to the door using the palm of the hand with a dry towel working from the rear edge of the door forward down the entire molding.