Blower Motor Control Module Replacement. Chevrolet Impala 2009

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Impala 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Blower Motor Control Module Replacement

Callout	Component Name
Preliminary Procedure Remove the right closeout insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side. Disconnect the blower motor resistor electrical connector.
1	Blower Motor Resistor Screw (Qty: 2) Caution: Refer to Fastener Caution in the Preface section. Tip Remove the heat stakes that secure the blower motor resistor to the HVAC module assembly using a small chisel. Tighten 1.5 N·m (13 lb in)
2	Blower Motor Resistor Refer to Control Module References for programming and setup information.

Callout

Component Name

Remove the right closeout insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side.
Disconnect the blower motor resistor electrical connector.

Blower Motor Resistor Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tip
Remove the heat stakes that secure the blower motor resistor to the HVAC module assembly using a small chisel.

Tighten
1.5 N·m (13 lb in)

Blower Motor Resistor

Refer to Control Module References for programming and setup information.