• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
Run/Crank Relay Coil Control | B1428 00 | 1 | 2 | -- |
1. No Start. SIR system will retain DTC B1370 06 as current. 2. Vehicle will start and continue to run after the ignition key is removed. |
The body control module (BCM) controls the IGN MAIN PCB relay through the run/crank relay coil control circuit by applying voltage to the circuit. The IGN MAIN PCB relay is energized when the ignition switch is in ON or START, or when a remote start is requested.
• | The system voltage is between 9-16 volts. |
• | The DTC can only run when the output is activated. |
The DTC will set only when the output is activated and there is a short to ground in the run/crank relay coil control circuit.
The module output driver will be shut down and not supply voltage to the run/crank relay coil control circuit.
• | The current DTC will clear when the module request for the output is removed or the malfunction is no longer present. |
• | A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction. |
• | Use the DMM MIN/MAX function to capture/locate intermittent conditions. |
• | Short to voltage in the run/crank relay coil control circuit will cause the malfunction indicator lamp (MIL) to illuminate with the ignition key OFF, and the engine will remain running if started and the ignition key is removed. |
Power Mode Description and Operation
Control Module References for scan tool information
⇒ | If less than specified, test the control circuit for a short to ground. If the circuit tests normal, replace the underhood fuse block. |
Perform the Diagnostic Repair Verification after completing the repair.
Accessory Wiring Junction Block Replacement
Refer to Control Module References for BCM replacement, setup, and programming