Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0242 71: Engine Control Module (ECM) Indicated TCS Malfunction invalid serial data received.DTC C0242 75: Engine Control Module (ECM) Indicated TCS Malfunction signal above allowable range.
DTC P0856 00: Traction Control Torque Request Circuit
Circuit/System Description
The electronic brake control module (EBCM) and the engine control module (ECM) simultaneously control the traction control. The EBCM sends a serial data message to the ECM requesting torque reduction. When certain ECM DTCs are set, the ECM will not be able to perform the torque reduction for traction control. A serial data message is sent to the EBCM indicating that traction control is not allowed.
Conditions for Running the DTC
| • | The ignition is ON. |
| • | Ignition voltage is greater than 8 volts. |
Conditions for Setting the DTC
The ECM diagnoses a condition preventing the engine control portion of the traction control function and sends a serial data message to the EBCM indicating that torque reduction is not allowed. The ECM will typically set DTC P0856 and the EBCM will set C0242.
Action Taken When the DTC Sets
| • | The EBCM disables the TCS for the duration of the ignition cycle. |
| • | The Traction Off indicator turns ON. |
| • | The DIC displays the Service Traction Control message. |
| • | The ABS remains functional. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present and the DTC is cleared with a scan tool. |
| • | The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for Scan Tool Information
Circuit/System Verification
Verify that no DTCs are set in the ECM.
| ⇒ | If DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
