GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B2615 00: Passenger Compartment Dimming 2 Circuit

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Body Control Module (BCM) B+ terminal 2 X4

B2615 00

B2615 00

--

--

Courtesy Lamps Control

B2615 00

1

1

--

1. Courtesy Lamps Malfunction

Circuit/System Description

Battery voltage for the courtesy lamps is supplied at all times, from the INT LIGHTS Fuse located in the underhood fuse block, to the body control module (BCM). When the BCM receives a signal to command the courtesy lamps ON, it applies voltage through the courtesy lamps supply voltage circuits to the courtesy lamps listed below.

    • The left and right I/P courtesy lamps
    • Dome lamp
    • Right front turn signal

Conditions for Running the DTC

Battery voltage must be between 9-16 volts.

Conditions for Setting the DTC

DTC B2615 00 will set for the following conditions:

    • The BCM detects a short to ground in the courtesy lamps control circuit.
    • The BCM detects a short to ground or an open/high resistance in the INT LIGHTS fuse B+ circuit terminal 2 X4.

Actions Taken When the DTC Sets

The BCM will not illuminate any courtesy lamps supplied by the courtesy lamps control circuit.

Conditions for Clearing the DTC

    • The condition responsible for setting the DTC no longer exists.
    • A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.

Reference Information

Schematic Reference

Interior Lights Dimming Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Interior Lighting Systems Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Testing

  1. Ignition OFF, disconnect the X4 harness connector at the BCM.
  2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 2 and ground.
  3. If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. Ignition OFF, connect the X4 harness connector at the BCM.
  5. Disconnect the harness connectors at the following components.
  6. • Left I/P Courtesy Lamp
    • Right I/P Courtesy Lamp
    • Dome Lamp - Coupe
    • Dome/Reading Lamp - Sedan
  7. Ignition ON, clear the DTC with a scan tool.
  8. Operate the vehicle within the conditions for running the DTC and verify the DTC does not reset.
  9. If the DTC resets, test the control circuits for a short to ground. If the circuits test normal, replace the BCM.
  10. Reconnect each component one at a time and verify that the DTC does not reset.
  11. If the DTC resets, test or replace the component responsible for setting the DTC.
  12. If all circuits and components test normal, replace the BCM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Dome Lamp Replacement
    •  Instrument Panel Courtesy Lamp Bulb Replacement
    •  Control Module References for BCM replacement, setup, and programming