Removal Procedure
Important: The ignition should always be OFF when removing or installing the throttle actuator control (TAC) module connectors.
- Remove the electrical connectors from the TAC module .
- Remove the TAC module from the multi-use module bracket shelf.
Installation Procedure
- Install the TAC module to the multi-use module bracket shelf with 3 nuts.
Notice: Refer to Fastener Notice in the Preface section.
- Connect the electrical connectors to the TAC module .
Tighten
Tighten the TAC module nuts to 9 N·m (80 lb in).
- Refer to
Control Module References for programming and setup information.