For 1990-2009 cars only
Removal Procedure
- Remove the rear bench seat from the vehicle. Refer to Rear Bench Seat Replacement .
- Fold the seat back forward.
- Partially remove seat back cover to gain access to the hinge bolts. Refer to Rear Seat Back Cushion Cover and Pad Replacement .
- Disconnect the seat back release cables from the hinge (2).
- Remove the bolts that retain the seat back hinge to the seat cushion frame.
- Remove the bolts that retain the seat back hinges to the seat back frame.
- Remove the seat back hinges from the seat back frame.
Installation Procedure
- Install the seat back hinges to the seat back frame.
- Install the bolts that retain the seat back hinge to the seat back frame .
- Install the bolts that retain the seat back hinge to the seat cushion frame (3).
- Connect the seat back release cables (2).
- Connect the hook and loop fastener at the rear corner of the seat cushion cover.
- Install the carpet covering the center of the seat cushion frame along the rear edge of the seat, near the inner hinge.
- Install the rear bench seat to the vehicle. Refer to Rear Bench Seat Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 30 N·m (22 lb ft).
Tighten
Tighten the bolts to 30 N·m (22 lb ft).
