Tools Required

J 43909 Manual Shift Shaft Seal Installer

1. Install a new manual shift shaft seal (1) onto J 43909  (2).
2. Using J 43909  (2) , drive the manual shift shaft seal (1) into the transmission case.
3. Make sure the manual shift shaft seal is seated on the bottom of the bore.



4. Install the nib of the park pawl assembly (1) through the keyhole in the manual shift shaft detent lever (2).
5. Rotate the park pawl assembly 180 degrees.



6. Place the roller end of the park pawl assembly (5) into the transmission case.
7. Align the manual shift shaft detent lever (3) so that:

•	The cockscomb of the detent lever is facing up.

•	The guide hole for the manual valve pin is facing forward.

•	The manual shift shaft hole in the detent lever is aligned with the manual shift shaft seal (2).

8. Slide the manual shift shaft (1) through the following components:

•	Manual shift shaft seal (2)

•	Manual shift shaft detent lever (3)

•	Manual shift shaft nut (4)

9. Install the manual shift shaft into the transmission case.



10. Install the manual shift shaft detent lever (2) onto the flats of the manual shift shaft (1).
11. Install the manual shift shaft nut (3) onto the manual shift shaft (1).
12. Install a crow's foot with a torque wrench onto nut (3).

Notice: Refer to Fastener Notice in the Preface section.

13. Hold the flats of the manual shift shaft (1) and tighten the manual shift shaft nut (3).

Tighten
Tighten nut (3) to 29 N·m (21 lb ft).





Notice: DO NOT mar the transmission case surface around the spherical pin when removing or installing the spherical pin. An unmarred surface is required to maintain the seal between the control valve assembly and the transmission case.

14. Install the spherical tip pin (2) into the transmission case.
15. Lightly tap the spherical tip pin (2) into position until the head of the pin (2) is seated against the transmission case.