Warning: Refer to Brake Dust Warning in the Preface section.
Note the location of the straps.
• | If the sensor retaining clip is still functioning correctly, save the clip for reinstallation. |
• | If the sensor retaining clip is not functioning correctly, replace the sensor retaining clip. |
Note: You may have to use the wire retainers from the old wheel speed sensor wire on the new sensor. Do not damage the new wire when installing the retainers.
Note: When the wheel speed sensor is fully installed in the block bore, it contacts the tone ring which is attached to the wheel hub. Normal bearing play between the sensor tip and tone ring in the wheel hub will move the sensor tip away from the tone ring. This automatically establishes the proper air gap.
The wire ties should not be spaced more than 6 inches apart.