GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Kodiak C-Series (Conventional) C6/C7/C8 🢒 Brakes 🢒 Air Brakes 🢒 Crankshaft Position System Variation Learn
  1. Install a scan tool.
  2. With a scan tool, monitor the powertrain control module for DTCs. If other DTCs are set, except DTCs P0315 or P1336, refer to Diagnostic Trouble Code (DTC) List for the applicable DTC that set.
  3. With a scan tool, select the crankshaft position variation learn procedure.
  4. The scan tool instructs you to perform the following items:
    5. • Accelerate to wide open throttle (WOT).
    • Release and observe the fuel cut-off for the engine that you are performing the learn procedure on.
    • Engine should not accelerate beyond calibrated RPM value.
    • Release throttle immediately if value is exceeded.
    • Block drive wheels.
    • Set parking brake.
    • DO NOT apply brake pedal.
    • Cycle the ignition from OFF to ON.
    • Apply and hold the brake pedal.
    • Start and idle engine.
    • Turn A/C OFF.
    • Vehicle must remain in Park or Neutral.
    • The scan tool monitors certain component signals to determine if all the conditions are met to continue with the procedure. The scan tool only displays the condition that inhibits the procedure. The scan tool monitors the following components:
       - Crankshaft position (CKP) sensors activity--If there is a CKP sensor condition, refer to the applicable DTC that set.
       - Camshaft position (CMP) sensor activity--If there is a CMP sensor condition, refer to the applicable DTC that set.
       - Engine coolant temperature (ECT)--If the engine coolant temperature is not warm enough, idle the engine until the engine coolant temperature reaches the correct temperature.
  5. With the scan tool, enable the crankshaft position system variation learn procedure.

    6. Important: While the learn procedure is in progress, release the throttle immediately when the engine starts to decelerate. The engine control is returned to the operator and the engine responds to throttle position after the learn procedure is complete.

  6. Accelerate to WOT.
  7. Release when the fuel cut-off occurs.
  8. The scan tool displays Learn Status: Learned this ignition. If the scan tool indicates that DTC P0315 or DTC P1336 (if applicable) ran and passed, the CKP variation learn procedure is complete. If the scan tool indicates DTC P0315 or DTC P1336 failed or did not run, refer to DTC P0315 or DTC P1336 (if applicable). If any other DTCs set, refer to Diagnostic Trouble Code (DTC) List for the applicable DTC that set.
  9. Turn OFF the ignition for 30 seconds after the learn procedure is completed successfully.