- Route the clutch cable through the vehicle.
- Install the clutch cable to the bracket.
Notice: Refer to Fastener Notice in the Preface section.
- If required, install the retention block over the clutch cable with the stud portion going through the clutch cable bracket and install the retention block nut.
Tighten
Tighten the retention block nut to 25 N·m (18 lb ft).
- Lubricate the clutch cable adjustment rod swivel shaft and the clutch lever eyelet with transmission range selector lever lubricant GM P/N 01051344 (Canadian P/N 00993037).
- Install the clutch cable adjustment rod swivel to the clutch lever.
- Install the clutch cable adjustment rod swivel retainer clip.
- Lower the vehicle, if required.
- Route the clutch cable through the front of dash.
- Install the clutch cable to the clutch pedal.
- Install the clutch cable retainer.
- Check the clutch adjustment. Refer to
Clutch Assembly Adjustment
.
- If the clutch cable bracket requires installation, on vehicles equipped with a L18 with a MM7/MSG/MPU/MSC,
install bracket with three bolts to the transmission.
Tighten
Tighten the bolts to 85 N·m (63 lb ft).
- If the clutch cable bracket requires installation, on vehicles equipped with a L18 or LB7 with a ML6, install the bracket to the
transmission with two bolts.
Tighten
Tighten the bolts to 46 N·m (34 lb ft).
- If the clutch cable bracket requires installation, on vehicles equipped with a LG4 or LG5 with a MUT, install the bracket to the
transmission with two bolts.
- If the clutch cable bracket requires installation, on vehicles equipped with a LG4 or LG5 with a MUT/MS9/MT3,
install the bracket to the transmission with two bolts.
Tighten
Tighten bolts to 40 N·m (30 lb ft).
- If the clutch cable bracket requires installation, on vehicles equipped with a LG4 or LG5 with a MK8/MK9,
install the bracket to the transmission with two bolts.
Tighten
Tighten bolts to 36 N·m (27 lb ft).
- If clutch cable bracket requires installation, on vehicles equipped with a LG4 or LG5 with a MK0/MLO/MM7/MM8/M69,
install the bracket to the transmission with three bolts.
Tighten
Tighten bolts to 85 N·m (63 lb ft).
- If equipped, install the clutch return spring. Refer to
Clutch Return Spring Replacement
.