Removal Procedure
- Remove the spring tab bolts.
- Discard the spring tab bolts.
- Remove the spring tabs.
- Discard the spring tabs.
- Remove the cap bolts.
- Inspect the bolts for the following conditions:
• | Discard the cap bolts if these conditions are present. |
- Remove the bearing assemblies as required.
- Remove the journal from the yoke .
- Remove the lubrication fitting.
- Clean the lubricant passages in the journal cross.
- Inspect the bearings for excessive looseness or brinelling. Replace the journal and the bearings if the bearings are worn, damaged or brinelled.
- Inspect the yokes for the following conditions:
• | Replace the yoke if these conditions are present. |
Installation Procedure
- Install the journal into the yoke.
- Install the bearing assemblies.
- Install the bearing straps if equipped.
- Install the NEW bolts.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the NEW cap bolts if equipped.
Tighten
Tighten the bolts to 71 N·m (52 lb ft).
- Install the NEW lubrication fitting.
- Apply lubricant through the NEW lubrication fitting. Refer to
Fluid and Lubricant Recommendations
.