GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Kodiak C-Series (Conventional) C6/C7/C8 🢒 Body 🢒 Body Front End 🢒 Hood Rear Seal Replacement

Removal Procedure

    Object Number: 206408 Size: SH
  1. Remove the screw and nut from both sides.
  2. Remove the hood outer seals from both sides.
  3. Remove the windshield washer hose from the seal.
  4. Remove the hood center seal.

Installation Procedure

    Object Number: 206408 Size: SH

    Important: Use the following procedure in order to install the hood center seal to the plenum panel: The seal has an interference fit on the cowl pinch-weld flange.

  1. Press the windshield washer hose into the seal.
  2. Install the hood outer seals. Fit the seal over the stud on the cowl.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the nut onto the stud.

    4. Tighten
    Tighten the nut to 8 N·m (71 lb in).

  4. Install the screw through the seal into the cowl.

    5. Tighten
    Tighten the screw to 8 N·m (71 lb in).