The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Power Window Schematics Connector End View Reference: Power Door Systems Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Does the driver power window operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
Operate the passenger window from the master switch. Does the passenger window operate properly? | Go to Step 4 | ||
4 |
Does the test lamp illuminate? | Go to Step 5 | Go to Step 7 |
5 |
Does the test lamp illuminate? | Go to Step 6 | Go to Step 8 |
6 |
Does the test lamp illuminate in both directions? | Go to Step 10 | Go to Step 9 |
7 | Test the power window motor left front up circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 13 | Go to Step 9 |
8 | Test the power window motor left front down circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 13 | Go to Step 10 |
9 | Inspect for poor connections at the driver power window master switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs. Did you find and correct the condition? | Go to Step 13 | Go to Step 11 |
10 | Inspect for poor connections at the driver power window motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs. Did you find and correct the condition? | Go to Step 13 | Go to Step 12 |
11 | Replace the driver power window master switch. Refer to Front Side Door Window Switch Replacement. Did you complete the repair? | Go to Step 13 | -- |
12 | Replace the driver power window motor. Refer to Front Side Door Window Regulator Motor Replacement. Did you complete the repair? | Go to Step 13 | -- |
13 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |