Removal Procedure
- Remove the 2 bolts that retain the seat belt to the seat. If equipped with front air suspension seat.
- Remove the bolt retaining the seat belt to the rear seat shoulder belt guide adjuster.
- Remove the pillar upper garnish molding. Refer to Upper Pillar Garnish Molding Replacement .
- Remove the pillar lower garnish molding. Refer to Lower Pillar Garnish Molding Replacement .
- Remove the seat belt clip from the body panel.
- Remove the bolt retaining the seat belt retractor to the body panel.
- Remove the seat belt retractor from the vehicle.
Installation Procedure
- Install the bolt securing the seat belt retractor to the body panel.
- Install the seat belt clip to the body panel.
- Install the pillar lower garnish molding. Refer to Lower Pillar Garnish Molding Replacement .
- Install the pillar upper garnish molding. Refer to Upper Pillar Garnish Molding Replacement .
- Install the bolt securing the seat belt to the rear seat shoulder belt guide adjuster.
- Install the 2 bolts that retain the seat belt to the seat. If equipped with front air suspension seat.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the seat belt retractor bolt to 55 N·m (40 lb ft).
Tighten
Tighten the seat belt to guide adjuster bolt to 55 N·m (40 lb ft).
Tighten
Tighten the seat belt to seat bolts to 55 N·m (40 lb ft).
