Removal Procedure
- Remove the six hex screws (1) from the locking hub assembly (2).
- Remove the locking hub assembly (2) from the front disc brake rotor hub.
Installation Procedure
Important: DO NOT pack the hublock body assembly or cap with grease. Excessive grease can cause excessive dialing effort and hub failure.
- Install the locking hub assembly (2) into the front disc brake rotor hub.
Notice: Refer to Fastener Notice in the Preface section.
- Install the six hex screws (1).
Tighten
Tighten the screws to 4 N·m (3 lb ft).