Special Tools

Caution: Refer to Fastener Caution in the Preface section.





Note: Ensure the teeth of the flywheel holding tool engage the engine flywheel teeth.

1. Install the J 42847 tool to the starter bolt holes and tighten the J 42847 tool bolts to 50 N·m (37 lb ft).



2. Remove the crankshaft balancer bolt and washer.



3. Install the J 42846 button onto the end of the crankshaft.



4. Install the J 24420-C puller , or equivalent, onto the crankshaft balancer.
5. Tighten the center screw of the J 24420-C puller until the crankshaft balancer is removed from the end of the crankshaft.



6. Remove the crankshaft balancer.



7. Remove the J 42847 tool .
8. Remove the J 42846 button .