For 1990-2009 cars only
Removal Procedure
- Remove the locknuts (4) and the washers (3) that connect the transverse rod (1) to the frame.
- Remove the locknuts (6) and the washers (2, 5) that fasten the transverse rod (4) to the axle housing (3).
- Remove the transverse rod (4).
- Remove the transverse rod bracket from the frame.
- Inspect the transverse rod bushings. If the transverse rod bushings are worn or damaged, remove the bushing from the transverse rod (1).
Installation Procedure
- Install the bushings in the transverse rod.
- Position the transverse rod (4) in the bracket on the axle housing (3).
- Install the following components:
- Install the following components:
Caution: Refer to Fastener Caution in the Preface section.
| • | Transverse rod bolts (1) |
| • | The washers (2) |
| • | The locknuts (6) that fasten the rod to the bracket |
Tighten
Tighten the locknut on the transverse rod taper pin to 298 N·m (220 lb ft) for models without GPG.
| • | The reinforcement bolts (7) |
| • | The washers (6, 3) |
| • | The locknuts (4) |
Tighten
Tighten the pin nuts on the transverse rod bar to 298 N·m (220 lb ft).
